Service Manual 21
Figure 22: Bracket Fastener
Figure 23: Side Panel Bracket
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. If the Side Panel Bracket is not already installed,
install it now. Using a 4 mm hex wrench, install the
four fasteners as shown in Figure 23.
Torque to 4.0 N-m (3.0 in-lbf).
3. Place the Side Panel onto the frame so that the
bracket rests on the frame. Align the holes in the Side
Panel with the holes in the frame.
4. Using a 4 mm hex wrench, install the three side
fasteners as shown in Figure 21.
Torque to 5.5 N-m (4.0 ft-lbf).
5. Using a 4 mm hex wrench, install the four front
fasteners (two each side) as shown in Figure 20.
Loosely install theses fasteners on both Side Panels
before tightening.
Torque to 4.0 N-m (3.0 ft-lbf).
6. Using a 4 mm hex wrench, install the bracket fastener
as shown in Figure 22.
Torque to 5.5 N-m (4.0 ft-lbf).
7. Install the following components:
a. Light Cluster (page 18)
b. Front Cowl (page 17)
c. Glove Box (page 16)
d. Bib Panel (page 14)
e. Storage Trays (page 13)
f. Battery Module (page 8)
8. Perform post-service tests(page 127).
24270-00004
5.5 N-m (4.0 ft-lbf)
24270-00004
4.0 N-m (3.0 ft-lbf)
Bracket
24031-00001
Body Panels
To Next Page
Loading...