SE-3 Patroller78
Siren
Tools Required: 4 mm hex wrench
10 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Main Splash Guard (page 26)
3. Locate the Siren on the front of the frame.
See Figure 108.
4. Reach behind the Right Side Panel and disconnect
the siren harness. See Figure 109.
5. Using a 10 mm socket wrench, loosen the nut on each
side of the Siren. See Figure 111.
6. Pull the Siren off the bracket.
7. Using a 4 mm hex wrench, remove the two fasteners
holding the bracket to the frame. See Figure 110.
8. Remove the bracket.
Figure 108: Siren
Figure 109: Siren Harness Connector
Siren
To Next Page
Loading...