SE-3 Patroller64
Front Brake Line
Replacing the Front Brake Line can be a messy job. Be careful
not to let any brake fluid get on the harnesses, electronics, or
rotor. Immediately wipe up any spilled brake fluid with a shop
towel.
Tools Required: 2.5 mm hex wrench
14 mm socket wrench
Wire cutters
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Light Cluster (page 18)
g. Front Fender (page 24)
3. Drain the brake fluid out of the front brake line
(see page 53).
4. Using a 14 mm socket wrench, disconnect the Banjo
Bolt from the Caliper. See Figure 93.
NOTICE
Place the Banjo Bolt in a container to catch any brake
fluid that drains out.
5. Using a 2.5 mm hex wrench, remove the three
P-Clips. See Figure 92.
6. Using wire cutters, remove the cable tie on the
steering column. See Figure 92.
7. Using a 14 mm socket wrench, disconnect the Banjo
Bolt from the Master Cylinder. See Figure 78.
8. Remove the brake line.
Figure 92: Front Brake Line
Brakes
Cable tie
P-Clips
2.5 N-m (1.8 ft-lbf)
P-Clip
Front Brake Line
23955-00001
To Next Page
Loading...