SE-3 Patroller96
Front Fork
Some text goes here.
Tools Required: SKF HN 8-9 spanner wrench
Torque wrench
UltraLube marine & trailer bearing grease
Permatex anti-seize lubricant
Vehicle jack
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Light Cluster (page 18)
g. Front Fender (page 24)
h. Front Splash Guard (page 25)
i. Front Fender Bracket (page 98)
j. Front Caliper (page 56)
k. Handlebar (page 94)
3. Jack up the front of the SE-3 Patroller (Figure 130).
WARNING!
Make sure the SE-3 Patroller is stable or use a jack
stand to stabilize it while the wheel is off the ground.
Failure to stabilize the SE-3 Patroller could result in
death or serious injury from the vehicle falling over.
4. Using an SKF HN 8-9 spanner wrench, remove the
two collar rings as shown in Figure 131.
5. Remove the Front Fork as shown in Figure 132.
23782-00001
45 N-m (33 ft-lbf)
Front Fork
(23777-00001)
Seal
(23792-00001)
Bearing
(23790-00001)
Figure 130: Front Lifting Point
Place jack here
Figure 131: Front Fork Collars
Steering Column
To Next Page
Loading...