Service Manual 35
Headlight Alignment
Always align the Headlight after performing any service that
affects the Headlight.
Tools Required: 4 mm hex wrench
10 mm socket wrench
Digital level
Torque wrench
Procedure
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Using a 4 mm hex wrench and a 10 mm socket
wrench, loosen the Headlight Bracket fasteners as
shown in Figure 40. Loosen just enough to adjust the
headlight angle.
3. Place a digital level on top of the bracket. Adjust the
bracket until it is at 12°.
4. Tighten the Headlight Bracket fasteners and torque
to 6.0 N-m (4.4 ft-lbf).
Figure 40: Headlight Bracket
24270-00004
23202-00004
6.0 N-m (4.4 ft-lbf)
Lights
To Next Page
Loading...