SE-3 Patroller76
Handlebar Grip
The Handlebar Grip does not slide off easily. To remove it, you
will have to cut it off the handlebar.
Tools Required: Cutting tool (box cutter or utility knife)
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Score the Handlebar Grip with a cutting tool.
CAUTION!
Be careful not to cut yourself with the sharp blade.
3. Grab the Handlebar Grip near the flange and tear it at
the score line you created.
4. Tear the Handlebar Grip and pull it off the handlebar.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Slide the end of the Handlebar Grip onto the left
handlebar. See Figure 107.
3. Press the palm of your hand onto the end of the
Handlebar Grip. Push the Handlebar Grip onto the
handlebar until it is fully seated.
NOTICE
Do not twist the Handlebar Grip when installing it.
Figure 107: Handlebar Grip
Handlebar Grip
(23807-00001)
Controls
To Next Page
Loading...