SE-3 Patroller16
Glove Box
The Gove Box fastens to the frame at the opening and rests on
studs on the frame at its other end.
Tools Required: 3 mm hex wrench
4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
3. Using a 4 mm hex wrench, remove the three
fasteners and Lock Plate as shown in Figure 13.
4. Gently lift the Glove Box off of the Frame.
5. Using a 3 mm hex wrench, remove the two fasteners
connecting the Service Port to the back of the Glove
Box (Figure 14).
6. Remove the Splash Shield (Figure 15).
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Install the Splash Shield (Figure 15).
3. Using a 3 mm hex wrench, attach the Service Port
harness to the back of the Glove Box (Figure 14).
Orient the connector with the narrow side down.
Torque to 1.6 N-m (1.2 ft-lbf).
4. Align the Glove Box on the frame. The back of the
Glove Box has holes which slide over studs in the
frame. The Glove Box opening has holes that line up
with the holes in the frame.
5. Using a 4 mm hex wrench, install the three fasteners
and Lock Plate as shown in Figure 13.
Torque to 1.6 N-m (1.2 ft-lbf).
6. Install the following components:
a. Bib Panel (page 14)
b. Storage Trays (page 13)
c. Battery Module (page 8)
7. Perform post-service tests (page 127).
Figure 13: Glove Box Fasteners
Figure 14: Service Port
20553-00001
1.6 N-m (1.2 ft-lbf)
24315-00001
1.6 N-m (1.2 ft-lbf)
24400-00001
1.6 N-m (1.2 ft-lbf)
Figure 15: Splash Shield
Splash Shield
(24419-00001)
Body Panels
To Next Page
Loading...