SE-3 Patroller86
Gearbox
Tools Required: 8 mm hex wrench
6 mm hex wrench
4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Fender (page 22)
e. Rear Tire/Wheel (page 30)
f. Rear Caliper & Rotor (page 62)
NOTICE
Leave the SE-3 Patroller jacked up and chock the
wheels.
WARNING!
Make sure the SE-3 Patroller is stable or use a jack
stand to stabilize it while the wheel is off the ground.
Failure to stabilize the SE-3 Patroller could result in
death or serious injury from the vehicle falling over.
3. Using a 8 mm hex wrench, remove the three
fasteners as shown in Figure 115.
4. Pull the Gearbox off of the chassis.
5. Make note of the O-ring and keep track of it.
See Figure 116.
6. If replacing the gearbox, remove the following
components as well:
a. Using a 6 mm hex wrench, remove the two
fasteners on the Caliper Bracket. Set the
Caliper Bracket aside. See Figure 117.
b. Using a 4 mm hex wrench, remove the three
fasteners on the Fender Bracket. Set the
Fender Bracket aside. See Figure 118.
Figure 115: Gearbox
20991-00002
67 N-m (49 ft-lbf)
Flat Washer
24434-00005
Drive Train
Figure 116: Gearbox O-Ring
O-Ring
23851-00001
To Next Page
Loading...