Service Manual 123
KeyLock Harness
This harness connects the PI Board to the KeyLock on the Bib
Panel.
Tools Required: Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Electronics Shield (page 100)
3. Disconnect the wire harness from the PI Board.
See Figure 171.
4. Using a pair of wire cutters, remove the cable tie
holding the harness to the top of the frame.
5. Remove the KeyLock Harness.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the wire harness to the PI Board.
See Figure 171.
3. Route the harness through the frame and up to the
top right of the frame. See Figure 172.
4. Install a cable tie at the top of the frame.
5. Install the following components:
a. Electronics Shield (page 100)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
6. Perform post-service tests (page 127).
Figure 171: KeyLock Harness to PI Board
Figure 172: KeyLock Harness Routing
Key
Harnesses
To Next Page
Loading...