SE-3 Patroller36
Accessing the Light Cluster
To acess the Light Cluster, remove the body panels listed
below.
Remove Body Panels
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
NOTICE
Some of the lights require plastic sleeves to be
installed on the fasteners. See Figure 43.
Install Body Panels
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Install the following components:
a. Front Cowl (page 17)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
Figure 41: Light Cluster Components
Side Strobe Light
Front Strobe Light
Directional Light
Stobe Lights
(Order Not Important)
Right
Directional Light
Left
Directional Light
Figure 42: Light Cluster Harness
Lights
Figure 43: Fastener with Plastic Sleeve
To Next Page
Loading...