Service Manual 39
Front Directional Light
Tools Required: 3 mm hex wrench
7 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Access the Light Cluster by following the instructions
to Remove Body Panels on page 36.
3. Disconnect the wire harness.
4. Using a 3 mm hex wrench and a 7 mm socket wrench,
remove the two fasteners securing the light.
See Figure 49.
5. Remove the light.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Feed the wire harness through the hole in the Light
Cluster and connect it to the Front Light Harness.
NOTICE
Connect the left-hand light to the connector labeled
“Left” and the right-hand light to the connector
labeled “Right.”
3. Slide the plastic sleeves onto the fasteners, then
install the fasteners and lock nuts (Figure 49).
4. Using a 3 mm hex wrench and a 7 mm socket wrench,
tighten the fasteners.
Torque to 1.6 N-m (1.2 ft-lbf).
CAUTION!
Do not overtighten. Overtightening may damage the
rubber seal around the light.
5. Reassemble the SE-3 Patroller by following the
instructions to Install Body Panels on page 36.
6. Perform post-service tests (page 127).
Figure 49: Front Directional Lights
23202-00001
1.6 N-m (1.2 ft-lbf)
24315-00002
Front Directional Light
(24251-00001)
Right
Directional
Light
Left
Directional
Light
Figure 50: Directional Light Connectors
Lights
To Next Page
Loading...