SE-3 Patroller22
Fender
The Fender attaches to the frame and gearbox bracket.
Tools Required: 4 mm hex wrench
10 mm socket wrench
Wire cutters
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
3. Using a 4 mm hex wrench, remove the six outside
fasteners and P-clip (Figure 24).
4. Using a 10 mm socket wrench, remove the lock nut
and P-clip on the back of the upper inside fastener.
5. Using a 4 mm hex wrench, remove the three inside
fasteners (Figure 25).
6. Reach inside the wheel well and disconnect the
Tail Light Harness from the Brake Light and Rear
Directional Light.
7. Lift the Fender off the frame.
Reach between the Fender and the Bracket; push the
center of the Fender away from the Bracket.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Place the Fender on the frame.
3. Connect the Tail Light Harness to the Brake Light and
Rear Directional Light.
4. Using a 4 mm hex wrench, install the three inside
fasteners (Figure 25). Place the longer fastener
through the upper hole.
Torque to 5.5 N-m (4.0 ft-lbf).
5. Install a P-clip around the Tail Light Harness and slide
it onto the back of the long fastener just installed.
6. Using a 10 mm socket wrench, install a lock nut to
hold the P-clip in place.
Torque to 5.5 N-m (4.0 ft-lbf).
7. Install a P-clip around the Tail Light Harness and
orient it as shown in Figure 24.
8. Using a 4 mm hex wrench, install the six outside
fasteners and the P-clip (see Figure 24).
Torque to 5.5 N-m (4.0 ft-lbf).
Figure 24: Outside Fasteners
Figure 25: Inside Fasteners
Body Panels
Fender
Left 23756-00001
Right 23757-00001
24270-00004
5.5 N-m (4.0 ft-lbf)
24270-00006
5.5 N-m (4.0 ft-lbf)
P-Clip
(24509-00001)
23202-00004
5.5 N-m (4.0 ft-lbf)
Some components not shown.
24270-00004
5.5 N-m (4.0 ft-lbf)
Fender
Push to
Remove
P-Clip
(24509-00001)