SE-3 Patroller116
Light Cluster Harness
This harness connects the PI Board to the directional lights
and the strobe lights in the Light Cluster.
Tools Required: Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Electronics Shield (page 100)
3. Disconnect the wire harness from the PI Board.
See Figure 158.
4. Using a pair of wire cutters, remove the cable tie
connecting the harness to the frame.
5. Using a pair of wire cutters, remove the cable ties
around the harness inside the Light Cluster.
6. Disconnect the wire harness from the lights.
See Figure 159.
7. Remove the Light Cluster Harness.
Figure 158: Light Cluster Harness to PI Board
Strobe Lights
(Order Not Important)
Right
Directional Light
Left
Directional Light
Figure 159: Light Cluster Harness Connectors
Front Lights
Harnesses
To Next Page
Loading...