Segway SE-3 Patroller - Page 123

Service Manual 115
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Insert the harness into the UI Housing and carefully
press the grommet into place. See Figure 156.
NOTICE
Do not use any sharp or pointed tools. You could
puncture the grommet, thereby allowing water to
enter the UI Housing.
3. Route the harness down the steering column and
around the left side of the frame. See Figure 157.
4. Connect the harness to the PI Board. See Figure 154.
5. Install four cable ties:
a. Two around the harnesses on the steering
column.
b. One connecting this harness to the
Handlebar Controls Harness near the
steering column.
c. One connecting this harness to the frame.
6. Install the following components:
a. UI Module (page 70)
b. Electronics Shield (page 100)
c. Front Cowl (page 17)
d. Glove Box (page 16)
e. Bib Panel (page 14)
f. Storage Trays (page 13)
g. Battery Module (page 8)
7. Perform post-service tests (page 127).
Figure 156: UI Harness Grommet
Harnesses
Figure 157: UI Harness Routing