SE-3 Patroller62
Rear Caliper & Rotor
Tools Required: 6 mm hex wrench
14 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Fender (page 22)
e. Rear Tire/Wheel (page 30)
NOTICE
Leave the SE-3 jacked up.
3. Chock the wheels.
4. Release the rear brake.
5. Using a 6 mm hex wrench, remove the two caliper
fasteners. See Figure 88.
6. Remove the Caliper and secure it so it doesn’t strain
the brake line.
7. Remove the Rotor and Spacer. See Figure 89.
Place the rotor on a clean surface.
NOTICE
Scratching the Rotor or introducing debris could
shorten the life of the Rotor.
8. To remove the Caliper:
a. Drain the brake line (page 53).
b. Using a 14 mm socket wrench, disconnect
the Banjo Bolt.
Figure 88: Rear Caliper
Figure 89: Rear Rotor
23868-00001
28.5 N-m (21.0 ft-lbf)
Rear Caliper
Right 23812-00001
Left 23810-00001
Spacer
24318-00001
Rear Rotor
23732-00001
Brakes
To Next Page
Loading...