SE-3 Patroller100
Electronics Shield
The Electronics Shield protects the PI Board and harnesses.
WARNING!
Wait two minutes after removing the Battery Module before
removing the Electronics Shield. This is how long it takes for
the capacitors on the PI Board to self-discharge. Touching the
PI Board before the capacitors have fully discharged could
result in electric shock.
Tools Required: 3 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
3. Using a 3 mm hex wrench, remove the four fasteners
as shown in Figure 134 and Figure 135.
4. Remove the Electronics Shield.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Orient the Electronics Shield with the opening toward
the top.
3. Using a 3 mm hex wrench, install the four fasteners
as shown in Figure 134 and Figure 135.
Torque to 2.5 N-m (1.8 ft-lbf).
4. Install the following components:
a. Glove Box (page 16)
b. Bib Panel (page 14)
c. Storage Trays (page 13)
d. Battery Module (page 8)
5. Perform post-service tests (page 127).
Figure 134: Left Side Fasteners
Figure 135: Right Side Fasteners
24491-00002
2.5 N-m (1.8 ft-lbf)
Power Interface
To Next Page
Loading...