SE-3 Patroller108
This harness provides power to the motor. There are separate
harnesses for the left motor and the right motor.
Tools Required: Wire cutters
10 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Light Cluster (page 18)
g. Side Panel (page 20)
NOTICE
Remove the left Side Panel to access the
Left Motor Power Harness. Remove the right
Side Panel to access the Right Motor Power
Harness.
h. Rider Detect Mat (page 82)
i. Motor Cavity Lid (page 89)
3. Disconnect the wire harness from the PI Board.
See Figure 144.
NOTICE
You do not need to remove the Electronics Shield to
access the Motor Power Harnesses.
4. Using a pair of wire cutters, remove the two cable ties
on the side of the frame.
5. Using a pair of wire cutters, remove the two cable ties
inside the motor cavity.
6. Using a 10 mm socket wrench, disconnect the power
leads from the Motor Controller. See Figure 146.
7. Remove the Motor Power Harness.
Figure 144: Motor Power Harnesses to PI Board
Left/Right Motor Power Harness
Harnesses
Figure 145: Motor Power Harnesses Routing
Brace
To Next Page
Loading...