Service Manual 109
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Using a 10 mm socket wrench, connect the leads to
the Motor Controller.
B+ Red
B– Black
Arrange the hardware stack as shown in Figure 147.
Torque to 7.5 N-m (5.5 ft-lbf).
3. Feed the harness through the hole in the front of the
motor cavity. Send the left Motor Power Harness out
the left side of the frame. Send the right Motor Power
Harness out the right side of the frame.
4. Feed the harness under the horizontal brace on the
frame and connect it to the PI Board.
See Figure 144.
5. Install two cable ties around the harnesses in the
motor cavity.
6. Install two cable ties around the harnesses on the
side of the frame. See Figure 145.
7. Install the following components:
a. Motor Cavity Lid (page 89)
b. Rider Detect Mat (page 82)
c. Side Panel (page 20)
d. Light Cluster (page 18)
e. Front Cowl (page 17)
f. Glove Box (page 16)
g. Bib Panel (page 14)
h. Storage Trays (page 13)
i. Battery Module (page 8)
8. Perform post-service tests (page 127).
Figure 146: Motor Power Harness to Motor Controller
Figure 147: Hardware Stack
Flat Washer
(24434-00003)
Lock Washer
(24435-00003)
24436-00004
7.5 N-m (5.5 ft-lbf)
Ring Terminal
Harnesses
To Next Page
Loading...