Service Manual 117
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the wire harness to the lights.
See Figure 159 & Figure 160.
3. Route harness around the left side of the frame.
4. Connect the wire harness to the PI Board.
See Figure 158.
5. Install two cable ties to hold the harness neatly and
tightly behind the Light Cluster.
6. Install a cable tie connecting this harness to the
frame.
7. Install the following components:
a. Electronics Shield (page 100)
b. Front Cowl (page 17)
c. Glove Box (page 16)
d. Bib Panel (page 14)
e. Storage Trays (page 13)
f. Battery Module (page 8)
8. Perform post-service tests (page 127).
Figure 160: Directional Light Connectors
Figure 161: Light Cluster Harness Routing
Right
Directional Light
Left
Directional Light
Harnesses
To Next Page
Loading...