Service Manual 75
Figure 106: Throttle Harness
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Spray some LPS Heavy Duty Silicone Lubricant
(P/N 24430-00001) on the first 100 mm of the
handlebar. This will help the Throttle to rotate
smoothly and evenly.
NOTICE
Do not apply lubricant where the Throttle clamps to
the Handlebar. This could reduce the holding power
of the Throttle clamp, allowing it to rotate.
3. Slide the Throttle onto the handlebar. Slide it until it
bottoms out, then pull it back 3–5 mm.
4. Using a digital level, align the Throttle so that the rear
face (rider side) is at 82°.
5. Using a Phillips screwdriver, tighten the two fasteners
on the underside of the Throttle.
Torque to 4.0 N-m (3.0 ft-lbf).
NOTICE
Tighten the fasteners carefully to make sure there is
an even and consistent gap between the two halves.
6. Connect the wire harness. See Figure 106.
grey & red/black
black & orange/black
7. Install two cable ties around the harnesses on the
steering column.
8. Install the following components:
a. Front Cowl (page 17)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
9. Perform post-service tests (page 127).
Controls
To Next Page
Loading...