Segway SE-3 Patroller - Page 87

Service Manual 79
Figure 110: Siren Bracket
Figure 111: Siren Fasteners
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Orient the bracket on the frame.
3. Using a 4 mm hex wrench, install the two bracket
fasteners. See Figure 110.
Torque to 7.5 N-m (5.5 ft-lbf).
4. Verify that the bolts are loosely installed on the
bracket.
5. Slide the Siren onto the bracket so the bolt heads go
through the slots on the sides of the siren.
6. Using a 10 mm socket wrench, tighten the nuts on
the bracket. See Figure 111.
Torque to 2.5 N-m (1.8 ft-lbf).
7. Thread the siren lead behind the Right Side Panel and
connect it to the Siren Harness. See Figure 108.
8. Install the following components:
a. Main Splash Guard (page 26)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
9. Perform post-service tests (page 127).
Siren
23839-00001
Siren Bracket
2.5 N-m (1.8 ft-lbf)
24270-00001
7.5 N-m (5.5 ft-lbf)
Siren