Segway SE-3 Patroller - Page 127

Service Manual 119
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the Tail Light Harness to the tail lights.
See Figure 164.
3. Install a P-clip around the Tail Light Harness and slide
it onto the back of the upper Fender Bracket fastener,
as shown in Figure 164.
4. Using a 10 mm socket wrench, install a lock nut to
hold the P-clip in place.
Torque to 5.5 N-m (4.0 ft-lbf).
5. Install a P-clip around the Tail Light Harness and
orient it as shown in Figure 163.
6. Using a 4 mm hex wrench, install a fastener to hold
the P-clip in place.
Torque to 5.5 N-m (4.0 ft-lbf).
7. Route the harnessunder the horizontal brace on the
frame. See Figure 165.
8. Connect the wire harness to the PI Board.
See Figure 162.
9. Install two cable ties connecting the harness to the
frame.
10. Install the following components:
a. Side Panel (page 20)
NOTICE
Ensure the harness goes over the wheel well
and under the storage tray.
b. Light Cluster (page 18)
c. Front Cowl (page 17)
d. Electronics Shield (page 100)
e. Glove Box (page 16)
f. Bib Panel (page 14)
g. Storage Trays (page 13)
h. Battery Module (page 8)
11. Perform post-service tests (page 127).
Harnesses
Figure 164: Tail Light Harness to Lights
Figure 165: Tail Light Harness Routing
Brace
P-Clip
(24509-00001)
23202-00004
5.5 N-m (4.0 ft-lbf)