SE-3 Patroller46
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Assemble the Battery Bumper. Slide the fastener
through the bumper, then slide washers onto the
fastener. See Figure 61.
NOTICE
Use the same number of washers as were removed
when the Battery Bumper was disassembled.
3. Using a 4 mm hex wrench, attach the Battery
Bumpers to the frame.
Torque to 2.0 N-m (1.5 ft-lbf).
4. Slide the three brake line P-Clips onto the threaded
studs on the front of the frame. See Figure 59.
5. Using an 8 mm socket wrench, install the lock nuts on
the threaded studs.
Torque to 1.4 N-m (1.0 ft-lbf).
6. Install the following components:
a. Main Splash Guard (page 26)
b. Front Fender Bracket (page 98)
c. Front Splash Guard (page 25)
d. Front Fender (page 24)
e. Battery Module (page 8)
7. Perform post-service tests (page 127).
Figure 61: Assembled Battery Bumper
Battery Compartment
24409-00008
2.0 N-m (1.5 ft-lbf)
Washers
To Next Page
Loading...