Service Manual 103
ACC Power
Steer Sensor
Charger
Right Drive Logic
Right
Drive
Power
Front Lights
Rear Strobe
Lights
Tail Lights
Siren
Left Right
User Interface
Left Drive Logic
Battery Connector
Key
Handle Bar
Service
Port
Left
Drive
Power
Rider
Detect
Mat
Slo-Blo Fuses
Fuses
Max
Speed
Figure 140: PI Board Components and Connectors
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Orient the PI Board and aluminum plate on the frame.
See Figure 139.
3. Using an 8 mm socket wrench, install the four nylock
nuts as shown in Figure 138.
Torque to 6.0 N-m (4.4 ft-lbf).
4. Connect all the harnesses.
See Figure 140.
5. Install the following components:
a. Charger (page 101)
b. Electronics Shield (page 100)
c. Glove Box (page 16)
d. Bib Panel (page 14)
e. Storage Trays (page 13)
f. Battery Module (page 8)
6. Perform post-service tests (page 127).
Power Interface
To Next Page
Loading...