Chapter 6: Installation Conditions and Method .............................................. 6-1 to 31
6-1 Installation conditions 6-1
[1] Lighting equipment 6-1
[2] Illuminance and shutter speed 6-3
[3] Optimum lens and resolution 6-4
6-2 Connection, installation, and wiring of IV-S20 main housing 6-8
[1] Connection 6-8
[2] Installation 6-10
[3] Connecting a power supply 6-12
[4] Connecting to the input/output terminals (parallel I/F) 6-14
[5] Connection for communications with personal computer (general purpose serial I/F) 6-16
[6] Connecting a programmable controller using the computer link function 6-18
6-3 Connection and installation methods of camera (IV-S20C1, IV-S30C1/C2) 6-19
[1] Connecting and installation to the IV-S20C1 6-19
[2] Installing and connecting the IV-S30C1 6-23
[3] Installing and connectiong the IV-S30C2 6-27
Chapter 7: Setting and Operating Outlines ...................................................... 7-1 to 14
7-1 Setting and operating procedures 7-1
7-2 Screen specifications 7-2
[1] Operation (run) screen 7-2
[2] Menu configuration 7-4
[3] Set condition configuration 7-7
[4] Image display 7-8
7-3 Remote key pad specifications 7-9
7-4 Operation flow 7-10
[1] Processing after power is turned ON and main loop processing 7-10
[2] Operation flow after a measurement start input signal is given 7-12
7-5 When using the IV-S30SP 7-14
Chapter 8: Run Menu Conditions and Settings................................................ 8-1 to 10
[1] Output monitor 8-1
[2] Image capture 8-3
[3] Message display 8-4
[4] Pattern display 8-5
[5] Binary image display 8-6
[6] θ angle correction image display 8-7
[7] Crosshair cursor display 8-8
[8] Manually setting the object type 8-9
[9] Image display 8-10
[10] Main operations menu lock 8-10
C-2
To Next Page
Loading...