Chapter 9 : Setting the Conditions for Each Object Type ............................. 9-1 to 117
9-1 Outline 9-1
9-2 Shared settings 9-3
[1] Window shape selection and settings 9-3
[2] Image settings 9-6
[3] Evaluation conditions 9-13
[4] Numerical calculations 9-14
[5] Position correction 9-20
[6] Comparative calculations between images 9-24
[7] Copying (editing) 9-28
[8] Editing after initialization 9-31
[9] Title registration 9-33
9-3 Positional deviation and absolute position measurement 9-34
9-4 Degree of match inspection for shape and size 9-45
9-5 Distance and angle measurement 9-57
9-6 Lead inspection 9-72
9-7 Area measurement by binary conversion 9-82
9-8 Counting quantities by binary conversion 9-90
9-9 Object identification (labeling) by binary conversion 9-98
9-10 Existence inspection by point measurement 9-107
9-11 System settings 9-115
[1] Illuminance (light level) monitor 9-115
[2] Shutter speed 9-117
Chapter 10: PC Function .................................................................................. 10-1 to 16
10-1 Operation cycle 10-1
[1] Power ON sequence 10-2
[2] PC scan clycle 10-2
[3] Measurement processing cycle 10-2
10-2 Ladder circuit program creation 10-3
[1] Procedure for creating measurement output condition and a ladder circuit 10-3
[2] Procedure for setting the final output conditions in a ladder circuit 10-8
10-3 Program examples (shape and positional deviation inspection) 10-14
10-4 Examples of a final output conditions ladder circuit 10-15
10-5 PC monitor screen 10-16
Chapter 11: Setting the Input/Output Conditions .......................................... 11-1 to 22
11-1 Outline 11-1
11-2 Measurement start input and result output settings 11-3
11-3 CCD trigger 11-17
11-4 Setting for serial communications 11-18
11-5 Computer link 11-19
11-6 Output block assignment (computer link output and general purpose serial output) 11-20
[1] Data in specified blocks 11-20
[2] Setting (operating) procedure 11-21
11-7 Gain/offset adjustment 11-22
C-3
To Next Page
Loading...