9-108
9
Existence inspection by point measurement
[1] Setting sequence
[Average
lightness]
[Binary
conversion]
Binary conversion
(Fixed/threshold values
correction)
Threshold
value (0 to 255)
These settings are found in the [TYPE00-MEAS1 to 3]
menu.
Point setting
Point setting
Processing mode
2COMPARE IMAGES
(comparative calculations
between images)
(see section 9-2 [6])
1MEAS SELECTION
(Select the POINT MEAS
(area measurement by
binary conversion))
7EVALUATION COND
(evaluation condition)
9OUTPUT CONDITIONS
(output condition)
[MAIN OPS MENU]
SET-SCRN
[SYSTEM SETUP]
2OBJECTTYPE COND
[OBJECT TYPE COND]
0MEASUREMENT 1
qMEASUREMENT 2
wMEASUREMENT 3
6MEAS.PROG.COND
(conditions for
measurement programs
4COPY,
5INTIALIZATION
(see section 9-2 [7], [8])
3SELECT
CAMERA
(select a
camera
MAIN OPS MENU
[OBJECT TYPE COND]
eFINAL CALC RESULT
(final numerical calculation)
(see section 9-2 [4])
[OBJECT TYPE COND]
rFINAL OUTPUT COND
(final output conditions)
(see “PC Function” in Chapter 10)
To Next Page
Loading...
Need help?
General