10-11
PC Function
10
[RESULTS OUTPUT]
(TYPE00)
1PAGE.NO. (0~7) REG.NO YES
2SET POSITION MOVE
3INPUT SIGNAL AUXRLY C112(0~127) EXT-INP X0(0~6)
TMR TM0(0~7) CNT CN0(0~7)
AN00(0~15) OUT Y00(0~15)
4LOGICAL SYMBOL
5OUTPUT SIGNAL OUT Y00(0~15) AUXRLY C000(0~127)
TMR TM0(0~7) SET-VL000(000~999)
CNT CN0(0~7) SET-VL000(000~999)
DEL.
6UPPER MENU
[PAGE0]
INPUT0
LOGIC
INPUT1
LOGIC
INPUT2
LOGIC
INPUT3
LOGIC
10 234567OUT
DEL.
3
1
2
C000
From the preceding page
[PAGE0]
INPUT0
LOGIC
C000
01234567OUT
Y00
Continued on the following page
(3) Ladder circuit 2 (setting output signals)
1. Move the cursor to item 2 SET POSITION with the up and down keys, and press the SET key.
- Move the cursor to the row where a ladder circuit output relay will be placed, and press the SET
key. An output relay can only be placed only on rows where input signals have already been
placed.
2. Move the cursor to item 5 OUTPUT SIGNAL with the up and down keys, and press the SET
key.
3. Select the kind of output signal and the number (set value). After moving the cursor to the
desired output signal with the left and right keys, select a number (set value) with the up and
down keys, and press the SET key.
-The output symbol and signal will be displayed on the row specified in step 1.
Display example:
To Next Page
Loading...
Need help?
General