SICK FLOWSIC200 - Safety Information and Protective Measures; General Information

10 FLOWSIC200 · Operating Instructions · 8013271/1CJ9/V 2-0/2022-01 · © SICK Engineering GmbH
Important information
1.6
Safety information and protective measures
1.6.1 General information
WARNING: General information
Improper use or handling can cause health or material damage. Read this
Section carefully and ensure you observe the safety precautions during all
work on the FLOWSIC200, as well as the warning and caution information in
the individual Sections of these Operating Instructions.
Adhere to the following:
 The relevant legal stipulations and associated technical regulations must be
observed when preparing and carrying out work on the installation.
 All work must be carried out in accordance with the local, system-specific
conditions and with due consideration to operating hazards and
specifications.
 The Operating Instructions belonging to the measuring system as well as
system documentation must be available on site. Always observe the
information on the prevention of injuries and damage given therein.
WARNING: Danger through power voltage
The FLOWSIC200 measuring system is an item of electrical equipment
designed for use in industrial high-voltage systems.
 Disconnect power supply lines before working on power connections or
parts carrying power voltage.
 Refit any contact protection removed before switching the power voltage
back on again.
 The device may only be operated with the cover closed.
 Before opening the cover, the device must be disconnected from the power
supply.
 The device must not be used when the electrical wiring (cables,
terminals, ...) is damaged.
WARNING:
WARNING: Hazards through ultrasonic signals
Do not expose unprotected hearing to the sonic beam of the transducer.
 Wearing suitable hearing protection is recommended when inspecting the
duct, connecting the device outside the duct or similar activities.
NOTICE:
The user must ensure:
 Neither failures nor erroneous measurements can lead to operational
states that can cause damage or become dangerous.
 The specified maintenance and inspection tasks are carried out regularly by
qualified, experienced personnel.