8 FLOWSIC200 · Operating Instructions · 8013271/1CJ9/V 2-0/2022-01 · © SICK Engineering GmbH
Important information
1.1 Function of this document
These Operating Instructions describe for the FLOWSIC200 measuring system:
● Device components
● Installation
● Operation
● For the maintenance work required for safe operation, detailed information on function
testing/device setting, data backup, software update, fault and error handling and
possible repairs, see the Service Manual.
Retention of documents
Keep these Operating Instructions and all associated documents available for
reference.
Pass the documents on to a new owner.
1.2 Scope of application
These Operating Instructions apply exclusively to the FLOWSIC200 measuring system
with the described system components.
They are not applicable for other SICK measuring devices.
These Operating Instructions cover only standard applications which conform with the
technical data specified. Additional information and assistance for special applications
are available from your SICK representative.
It is generally recommended to take advantage of qualified consulting services provided
by SICK experts for your specific application.
1.3 Target groups
This Manual is intended for persons who install, operate and maintain the device.
Requirements for personnel qualification
The measuring system may only be installed and operated by skilled technicians who,
based on their technical training and knowledge as well as knowledge of the relevant
regulations, can assess the tasks given and recognize the hazards involved. Skilled
technicians are persons according to DIN VDE 0105, DIN VDE 1000-10 or IEC 60050-
826 or directly comparable standards.
The persons named must have precise knowledge of operational hazards, e.g. due to low
voltage, hot, toxic, explosive or pressurized gases, gas-liquid mixtures or other media, as
well as sufficient knowledge of the measuring system through training.
To Next Page
Loading...
