SICK FLOWSIC500

38 FLOWSIC500 · Operating Instructions · 8025733/1GMJ/V4-2/2022-07 · © SICK Engineering GmbH
Installation
Subject to change without notice
3.1 Hazards during installation
3.2 General information
3.2.1 Delivery
The FLOWSIC500 is delivered preassembled in sturdy packaging.
▸ Inspect for transport damage when unpacking the device.
▸ Document any damage found and report this to the manufacturer.
▸ Check the scope of delivery for completeness.
The standard scope of delivery comprises:
● FLOWSIC500 (gas flow meter and adapter, already fitted),
● Backup battery (if device is configured for external power supply), or
● 2 battery packs (if device is configured for battery operation).
CAUTION: General risks during installation
▸ Observe applicable valid regulations, general standards and guidelines.
▸ Observe local safety regulations, operating instructions and special
regulations.
▸ Observe the safety information in → p. 10, §1.1.
▸ Comply with the safety requirements of Pressure Equipment Directive
2014/68/EC or ASME B31.3 when installing pressure devices including
connection of various pressure devices.
▸ Persons carrying out installation work must be familiar with the directives
and standards applicable for pipeline construction and have the
corresponding qualifications, e.g. in accordance with DIN EN 1591-4.
WARNING: Hazards through the gas in the system
The following conditions can increase the risk:
• Toxic gas or gas dangerous to health
• Explosive gas
• High gas pressure
▸ Only carry out installation, maintenance and repair work when the system is
non-pressurized.
WARNING: Hazards during installation work
▸ Do not carry out any welding work on lines with meters fitted.
▸ Comply exactly with mandatory and approved methods.
▸ Observe and comply with regulations of the plant operator.
▸ Meticulously check completed work. Ensure leak tightness and strength.
Otherwise hazards are possible and safe operation is not ensured.
NOTICE:
Do not put the FLOWSIC500 into operation if you notice any damage!