140 FLOWSIC500 · Operating Instructions · 8025733/1GMJ/V4-2/2022-07 · © SICK Engineering GmbH
Annex
Subject to change without notice
9.1 Conformities and Technical Data
9.1.1 CE certificate
The FLOWSIC500 has been developed, manufactured and tested in accordance with the
following EU Directives:
● Pressure Equipment Directive 2014/68/EU
● ATEX Directive 2014/34/EU
● EMC Directive 2014/30/EU
● Measuring Instrument Directive 2014/32/EU
Conformity with the above Directives has been determined and the CE label attached to the
device.
9.1.2 Standards compatibility
The FLOWSIC500 conforms to the following standards or recommendations:
● OIML R137-1&2, 2012
Gas Meters - Part 1: Metrological And Technical Requirements; Part 2: Metrological
Controls And Performance Tests
● EN 60079-0:2012/A11:2013, EN 60079-11:2012, EN 60079-28:2007
Explosive atmospheres - Part 0: Equipment - General requirements; Part 11: Equipment
protection by intrinsic safety “i”; Part 28: Protection of equipment and transmission
systems using optical radiation
● IEC 60079-0: 2011, IEC 60079-28: 2011 (6th Edition)
Explosive atmospheres - Part 0: Equipment - General requirements; Part 28: Protection
of equipment and transmission systems using optical radiation
● IEC 60079-11: 2011+Cor.: 2012 (6th Edition)
Explosive atmospheres - Part 11: Equipment protection by intrinsic safety “i”
● EN 61326-1:2006
Electrical equipment for measurement, control and laboratory use - EMC requirements -
Part 1: General requirements (IEC 61326-1:2005)
● IEC 61326:2005
Electrical equipment for measurement, control and laboratory use – EMC requirements
● EN 61010-1:2010
Safety requirements for electrical equipment for measurement, control, and laboratory
use - Part 1: General requirements (IEC 61010-1:2010)
● IEC 61010-1:2010 + Cor.: 2011
Safety requirements for electrical equipment for measurement, control and laboratory
use - Part 1: General requirements
● EN 12405-1+A2:2010-10
Gas meters - Conversion devices - Part 1: Volume conversion