10 FLOWSIC500 · Operating Instructions · 8025733/1GMJ/V4-2/2022-07 · © SICK Engineering GmbH
Important information
Subject to change without notice
1.1 Main hazards
1.2 About this document
This Manual describes:
– Device components
– Installation
– Operation of the FLOWSIC500.
It contains the main safety information for safe operation of the FLOWSIC500.
Application area of the document
This document is valid for FLOWSIC500 with firmware version 2.15.00 and higher.
FLOWSIC500 with Ex approval acc. CSA
DANGER: Risk of explosion when the gas flow meter is damaged
Natural gas flows with line pressure through the gas flow meter. Natural gas
can escape when the gas flow meter is damaged which creates a risk of
explosion.
▸
Prevent any possible damage to the gas flow meter. When necessary, fit
protection devices.
▸
If the gas flow meter is damaged: Stop natural gas feed immediately and
purge the FLOWSIC500 with inert gas.
WARNING: Hazards through leaks
Operation in leaky condition is not allowed and potentially dangerous.
▸
Regularly check leak tightness of equipment.
NOTICE:
For a French translation of this document, please refer to document 8025734
"Manuel d'utilisation FLOWSIC500".
To Next Page
Loading...
Need help?
General
