80 FLOWSIC500 · Operating Instructions · 8025733/1GMJ/V4-2/2022-07 · © SICK Engineering GmbH
Operation
Subject to change without notice
5.1 Control unit
Fig. 45 Operating and display elements
5.2
Operating using the display
▸
Press any button to switch the display on.
1
3
2
1 Display
2 Buttons
3 Optical data interface
In battery operation, the display and the optical data interface have a timeout
and switch off after approx. 60 seconds (default setting) when not button has
been pressed and no data transmission takes place.
The display and the optical interface are permanently active when an external
power supply is connected.
Table 23 Buttons
In menu In Edit mode
Esc
Returns to next higher level of the
operator menu
Aborts input of new value and returns
to the next higher level of the operator
menu.
Toggles between single menu entries
on one level
Increments or decrements a parameter
by 1, toggles between several selection
options.
ENTER Calls a submenu, starts edit mode. Confirms an input.
To Next Page
Loading...
