SICK nanoScan3

In the F
ields area, you draw the fields in a field set using the tools in the toolbar. In
the Field set area, you create the field sets and fields. In the area below, you configure
details for the selected field set or field.
The edge length or the diameter of each field must be at least as large as the selected
object resolution.
The fields of a field set are displayed in the monitoring case table in the same
sequence in which you create the fields.
Toolbar
Usin
g the tools in the field editor, you can draw the fields in a field set or masked areas
inside the fields.
Table 14: Buttons on the toolbar
Arrow tool, for marking objects
Hand tool, for moving the work space
Draw reference contour field or contour detection field
Draw field using points
Draw rectangle
Draw circle
Draw circle segment
Mask areas. Clicking this button shows the buttons for drawing fields with a
ha
tched display. You can then draw in areas that cannot be monitored.
Enable propose field
Editing a field using coordinates
Push the object into the foreground or background
Select field design
Zoom in
Zoom out
Zoom to area
Zoom to work space
Show snapshot of the spatial contour. Clicking again clears the spatial con‐
tour shown.
Show live spatial contour
Insert background image
Calculate field
CONFIGURATION 7
8027909/2023-02-22 | SICK O P E R A T I N G I N S T R U C T I O N S | nanoScan3 – EtherNet/IP™
73
Subject to change without notice