UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
102 A50010-Y3-C150-2-7619
The following is an example of displaying information of the running processes.
SWITCH# show process
USER PID %CPU %MEM VSZ RSS TTY STAT START TIME COMMAND
admin 1 0.2 0.2 1448 596 ? S 20:12 0:05 init [3]
admin 2 0.0 0.0 0 0 ? S 20:12 0:00 [keventd]
admin 3 0.0 0.0 0 0 ? SN 20:12 0:00 [ksoftirqd_CPU0]
admin 4 0.0 0.0 0 0 ? S 20:12 0:00 [kswapd]
admin 5 0.0 0.0 0 0 ? S 20:12 0:00 [bdflush]
admin 6 0.0 0.0 0 0 ? S 20:12 0:00 [kupdated]
admin 7 0.0 0.0 0 0 ? S 20:12 0:00 [mtdblockd]
admin 8 0.0 0.0 0 0 ? SW< 20:12 0:00 [bcmDPC]
admin 9 1.4 0.0 0 0 ? SW< 20:12 0:29 [bcmCNTR.0]
admin 10 1.4 0.0 0 0 ? SW< 20:12 0:29 [bcmCNTR.1]
admin 17 0.0 0.0 0 0 ? SWN 20:12 0:00 [jffs2_gcd_mtd3]
admin 149 0.0 0.3 1784 776 ? S Jan01 0:00 /sbin/syslogd –m
admin 151 0.0 0.2 1428 544 ? S Jan01 0:00 /sbin/klogd -c 1
admin 103 2.6 2.0 20552 5100 ? S 20:12 0:53 /usr/sbin/swchd
--more--
(Omitted)
SWITCH#
6.3.13 Displaying System Image
To check a current system image version, use the following command.
Command Mode Description
show version
Enable
Global
Shows version of system image.
To display a size of the current system image, use the following command.
Command Mode Description
show os-size
Enable
Global
Shows size of system image.
6.3.14 Displaying Installed OS
To display utilization of flash memory, use the followng command.
Command Mode Description
show flash
Enable
Global
Shows utilization of flash memory.
6.3.15 Default OS
The hiD 6615 S223/S323 supports dual OS You can show the flash memory by using
show system command. When there are two kinds of system images installed, user can
To Next Page
Loading...
