Siemens S223 - Source Port of Statistical Data; Subject of RMON History; Number of Sample Data; Interval of Sample Inquiry

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 127
want to list available commands.
The following is an example of listing available commands on RMON Configuration mode.
SWITCH(config-rmonhistory[5])# ?
RMON history configuration commands:
active Activate the history
data-source Set data source port
do To run exec commands in config mode
exit End current mode and down to previous mode
help Description of the interactive help system
interval Define the time interval for the history
owner Assign the owner who define and is using the history
resources
requested-buckets Define the bucket count for the interval
show Show running system information
SWITCH(config-rmonhistory[5])#
7.4.1.1 Source Port of Statistical Data
To specify a source port of statistical data, use the following command.
Command Mode Description
data-source NAME RMON
Specifies a data object ID.
NAME: enters a data object ID. (ex. ifindex.n1/port1)
7.4.1.2 Subject of RMON History
To identify subject using RMON history, use the following command.
Command Mode Description
owner NAME RMON
Identifies subject using related data, enter the name
(max. 32 characters).
7.4.1.3 Number of Sample Data
To configure the number of sample data of RMON history, use the following command.
Command Mode Description
requested-buckets <1-65535> RMON
Defines a bucket count for the interval, enter the num-
ber of buckets.
1-65535: bucket number (default: 50)
7.4.1.4 Interval of Sample Inquiry
To configure the interval of sample inquiry in terms of second, use the following command.
Command Mode Description
interval <1-3600> RMON
Defines the time interval for the history (in seconds),
enter the value. (default: 1800)