User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 29
3.1.1 Privileged EXEC View Mode
When you log in to the switch, the CLI will start with Privileged EXEC View mode that is a
read-only mode. In this mode, you can see a system configuration and information with
several commands.
Tab. 3.1 shows main command of Privileged EXEC View mode.
Command Description
enable Opens Privileged EXEC Enable mode.
exit Logs out the switch.
show Shows a system configuration and information.
Tab. 3.1 Main Commands of Privileged EXEC View Mode
3.1.2 Privileged EXEC Enable Mode
To configure the switch, you need to open Privileged EXEC Enable mode with the enable
command, then the system prompt will changes from SWITCH> to SWITCH#.
Command Mode Description
enable View Opens Privileged EXEC Enable mode.
You can set a password to Privileged EXEC Enable mode to enhance security. Once set-
ting a password, you should enter a configured password, when you open Privileged
EXEC Enable mode.
Tab. 3.2 shows main commands of Privileged EXEC Enable mode.
Command Description
clock Inputs time and date in system.
configure terminal Opens Configuration mode.
telnet Connects to another device through telnet.
terminal length Configures the number of lines to be displayed in screen.
traceroute Traces transmission path of packet.
where Finds users accessed to system through telnet.
Tab. 3.2 Main Commands of Privileged EXEC Enable Mode
3.1.3 Global Configuration Mode
In Global Configuration mode, you can configure general functions of the system. You can
also open another configuration mode from this mode.
To open Global Configuration mode, enter the configure terminal command, and then
the system prompt will be changed from SWITCH# to SWITCH(config)#.
Command Mode Description
configure terminal Enable
Opens Global Configuration mode from Privileged
EXEC Enable mode.
To Next Page
Loading...
