Siemens S223 - Manual Switch to Secondary; Wait-To-Restore Time; Learning Disable Time; Test Packet Interval

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 269
8.9.3.6 Manual Switch to Secondary
To configure Manual Switch to Secondary, use the following command.
Command Mode Description
erp ms-s DOMAIN-ID Bridge Configures ERP manual switch to secondary
To disable Manual Switch to Secondary, use the following command.
Command Mode Description
no erp ms-s DOMAIN-ID Bridge Disables ERP manual switch to secondary
8.9.3.7 Wait-to-Restore Time
To configure Wait-to-Restore Time, use the following command.
Command Mode Description
erp wait-to-restore DOMAIN-ID
<1-720>
Bridge
Configures ERP wait-to-restore time
1-720: Wait to restore time in second
To return the configured Wait-to-Restore Time as Default, use the following command.
Command Mode Description
no erp wait-to-restore DOMAIN-
ID
Bridge Configures ERP wait-to-restore time as default value
8.9.3.8 Learning Disable Time
To configure ERP Learning Disable Time, use the following command.
Command Mode Description
erp learn-dis-time DOMAIN-ID
<0-500>
Bridge
Configures ERP learning disable time
0-500: learning disabling time (unit: millisecond)
To return the configured Learning Disable Time as Default, use the following command.
Command Mode Description
no erp learn-dis-time DOMAIN-ID Bridge Configures ERP learning disable time as default value
8.9.3.9 Test Packet Interval
To configure ERP Test Packet Interval, use the following command.
Command Mode Description
erp test-packet-interval DO-
MAIN-ID <10-500>
Bridge
Configures ERP test packet interval
10-500: packet interval (unit: millisecond)