User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 157
Command Mode Description
max-hosts PORTS <1-16>
Limits the number of connection to a port by setting
maximum host:
PORTS: enter the port number.
1-16: enter the maximum MAC number.
no max-hosts PORTS
Bridge
Deletes configured max-host, enter the port number.
The following is an example of configuring to allow two MAC addresses to port 3, and five
addresses to port 1, 2, and to ten addresses to port 7.
SWITCH(bridge)# max-hosts 3 2
SWTICH(bridge)# max-hosts 1 5
SWTICH(bridge)# max-hosts 2 5
SWTICH(bridge)# max-hosts 7 10
SWTICH(bridge)#
To display configured max host, use the following command.
Command Mode Description
show max-hosts
Enable
Global
Bridge
Shows configured max host.
The following is an example of displaying configured max hosts.
SWITCH(bridge)# show max-hosts
port 1 : 0/5 (current/max)
port 2 : 0/5 (current/max)
port 3 : 0/2 (current/max)
port 4 : 0/Unlimited (current/max)
port 5 : 0/Unlimited (current/max)
port 6 : 0/Unlimited (current/max)
port 7 : 0/10 (current/max)
port 8 : 0/Unlimited (current/max)
port 9 : 0/Unlimited (current/max)
port 10 : 0/Unlimited (current/max)
7.9.1 Max New Hosts
Max-new-hosts feature is to limit the number of users by configuring the number of MAC
address that can be learned on the system and on the port for a second. The number of
MAC address that can be learned on the system has the priority.
To Next Page
Loading...
