Siemens S223 - Priority of Member Port; Priority of Switch

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
198 A50010-Y3-C150-2-7619
To delete key value of configured member port, use the following command.
Command Mode Description
no lacp port admin-key PORTS Bridge
Deletes key value of selected member port, select the
member port number.
8.2.2.7 Priority of Member Port
To configure priority of LACP member port, use the following command.
Command Mode Description
lacp port priority PORTS <1-
65535>
Bridge
Sets the LACP priority of member port, select the port
number. (default: 32768)
To remove port priority of configured member port, use the following command.
Command Mode Description
no lacp port priority PORTS Bridge
Deletes port priority of selected member port, select
the member port number.
8.2.2.8 Priority of Switch
In case the member ports of connected switches are configured as Active mode (LACP
system enabled), it is required to configure which switch would be a standard for it. For
this case, the user could configure the priority on switch. The following is the command of
configuring the priority of the switch in LACP function.
Command Mode Description
lacp system priority <1-65535> Bridge
Sets the priority of the switch in LACP function, enter
the switch system priority. (default: 32768)
To delete the priority of configured switch, use the following command.
Command Mode Description
no lacp system priority Bridge Clears the priority of the configured switch.