Siemens S223 - Activating RMON Alarm; Deleting Configuration of RMON Alarm; Displaying RMON Alarm; RMON Event

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
132 A50010-Y3-C150-2-7619
To configure interval of sample inquiry for RMON alarm, use the following command.
Command Mode Description
sample-interval <0-65535> RMON
Configures interval of sample inquiry.
(unit: second)
7.4.2.8 Activating RMON Alarm
After finishing all configurations, you need to activate RMON alarm. To activate RMON
alarm, use the following command.
Command Mode Description
active RMON Activates RMON alarm.
7.4.2.9 Deleting Configuration of RMON Alarm
When you need to change a configuration of RMON alarm, you should delete an existing
RMON alarm.
To delete RMON alarm, use the following command.
Command Mode Description
no rmon-alarm <1-65535> Global
Deletes RMON history of specified number, enter the
value for deleting.
7.4.2.10 Displaying RMON Alarm
To display RMON alarm, use the following command.
Command Mode Description
show running-config rmon-
alarm
All Shows a configured RMON alarm.
7.4.3 RMON Event
RMON event identifies all operations such as RMON alarm in the switch. You can config-
ure event or trap message to be sent to SNMP management server when sending RMON
alarm.
You need to open RMON Event Configuration mode to configure RMON event.
Command Mode Description
rmon-event <1-65535> Global
Opens RMON Event Configuration mode.
1-65535: index number
7.4.3.1 Event Community
When RMON event is happened, you need to input community to transmit SNMP trap
message to host. Community means a password to give message transmission right.