Siemens S223 - Route-Map Configuration Mode; Tab. 3.12 Main Commands of Route-Map Configuration Mode

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 35
3.1.12 Route-Map Configuration Mode
To open Route-map Configuration mode, use the following command. The prompt is
changed from SWITCH(config)# to SWITCH(config-route-map)#.
Command Mode Description
route-map NAME {permit | deny}
<1-65535>
Global Opens Route-map Configuration mode.
On Route-map Configuration mode, you can configure the place where information is
from and sent in routing table.
Tab. 3.12 shows a couple of important main commands of Route-map Configuration
mode.
Command Description
match Transmits routing information to specified place.
set Configures router address and distance.
Tab. 3.12 Main Commands of Route-map Configuration Mode