Siemens S223 - Displaying User Connecting to System; MAC Table

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 99
The following is an example of tracing packet route sent to 10.2.2.20.
SWITCH# traceroute 10.2.2.20
traceroute to 10.2.2.20 (10.2.2.20), 30 hops max, 38 byte packets
1 10.2.2.20 (10.2.2.20) 0.598 ms 0.418 ms 0.301 ms
SWITCH#
6.3.4 Displaying User Connecting to System
To display current users connecting to the system from a remote place or via console in-
terface, use the following command.
Command Mode Description
where Enable
Shows current users connecting to the system from a
remote place or via console interface.
The following is an example of displaying if there is any accessing user from remote place.
SWITCH# where
admin at ttyp0 from 10.20.1.32:2196 for 30 minutes 35.56 seconds
admin at ttyS0 from console for 28 minutes 10.90 seconds
SWITCH#
6.3.5 MAC Table
To display MAC table recorded in specific port, use the following command.
Command Mode Description
show mac BRIDGE [PORTS]
Enable
Global
Bridge
Shows MAC table.
BRIDGE: bridge name
The following is an example of displaying MAC table recorded in default.
SWITCH(config)# show mac 1
port mac addr permission in use
==================================================================
eth01 00:0b:5d:98:92:da OK 16.62
eth01 00:14:c2:d9:8a:b5 OK 56.62
eth01 00:01:02:50:d6:b9 OK 72.62
eth01 00:0d:9d:8c:00:ee OK 72.62
eth01 00:15:00:39:4d:2e OK 92.62
eth01 00:0e:e8:8b:24:ae OK 115.48
eth01 00:14:c2:d9:4c:f0 OK 115.48
eth01 00:0b:5d:53:4d:96 OK 124.62
eth01 00:13:20:4b:05:af OK 132.62
eth01 00:0e:e8:f0:b3:63 OK 152.62
(skipped)
SWITCH(config)#