UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
146 A50010-Y3-C150-2-7619
7.6.2.7 Displaying Rule
The following command can be used to show a certain rule by its name, all rules of a cer-
tain type, or all rules at once sorted by rule type.
Command Mode Description
show rule NAME
Shows a rule, enter a rule name.
NAME: rule name
show rule Shows all rules sorted by type.
show rule all Shows all rules and admin access rules sorted by type.
show rule statistics
Enable
Global
Shows rule statistics.
show rule-profile Rule Shows a current configuration of a rule.
The following is an example of configuring specific rule action on rule profile and showing
it.
SWITCH# configure terminal
SWITCH(config)# rule jean create
SWITCH(config-rule[jean])# priority low
SWITCH(config-rule[jean])# match copy-to-cpu
SWITCH(config-rule[jean])# apply
SWITCH(config-rule[jean])# exit
SWITCH(config)# rule jean create
% Already exist rule
SWITCH(config)# show rule
rule jean
priority low
port any any
match copy-to-cpu
SWITCH(config)# rule jean modify
SWITCH(config-rule[jean])no match copy-to-cpu
SWITCH(config-rule[jean]) show rule
rule jean
priority low
port any any
SWITCH(config-rule[jean])
7.6.3 QoS
For hiD 6615 S223/S323, it is possible to use Strict Priority Queuing, Weighted Round
Robin and Weighted Fair Queuing for a packet scheduling mode.
The following steps explain how QoS can be configured.
•
Scheduling Algorithm
•
Qos Weight
•
802.1p Priory-to-queue Mapping
•
Queue Parameter
•
Displaying QoS
To Next Page
Loading...
