UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
80 A50010-Y3-C150-2-7619
5.2.8 Port Status
To display a port status, use the following command.
Command Mode Description
show port PORTS Shows configured state of port, enter the port number.
show port description [PORTS]
Shows port specific description (max. number of char-
acters is 100), enter the port number.
show port module-info [PORTS]
Enable
Global
Bridge
Shows port module information.
The following is an example of displaying port information for port 1 to 12.
SWITCH# show port 1-12
------------------------------------------------------------------------
NO TYPE PVID STATUS MODE FLOWCTRL INSTALLED
(ADMIN/OPER) (ADMIN/OPER)
------------------------------------------------------------------------
1: Ethernet 1 Up/Down Force/Full/0 Off/ Off Y
2: Ethernet 1 Up/Down Force/Full/0 Off/ Off Y
3: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
4: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
5: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
6: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
7: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
8: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
9: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
10: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
11: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
12: Ethernet 1 Up/Down Auto/Full/0 Off/ Off Y
SWITCH#
5.2.9 Initializing Port Statistics
To clear all recorded statistics of port and initiate, use the following command. It is possi-
ble to initiate statistics of port and select specific port.
Command Mode Function
clear port statistics {PORT ㅣall}
Global
Initializes port statistics. It is possible to select several
ports.
5.3 Port Mirroring
Port mirroring is the function of monitoring a designated port. Here, one port to monitor is
called monitor port and a port to be monitored is called mirrored port. Traffic transmitted
from mirrored port is sent to monitor port so that user can monitor network traffic.
The following is a network structure to analyze the traffic by port mirroring It analyzes traf-
fic on the switch and network status by configuring Mirrored port and Monitor port con-
necting the computer, that the watch program is installed, to the port configured as Moni-
tor port.
To Next Page
Loading...
