User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 81
Fig. 5.2 Port Mirroring
To configure port mirroring, designate mirrored ports and monitor port. Then enable port
mirroring function. Monitor port should be connected to the watch program installed PC.
You can designate only one monitor port but many mirrored ports for one switch.
Step 1
Activate the port mirroring, using the following command.
Command Mode Description
mirror enable Bridge Activates port mirroring.
Step 2
Designate the monitor port, use the following command.
Command Mode Description
mirror monitor {PORTS I cpu} Bridge Designates the monitor port.
Step 3
Designate the mirrored ports, use the following command.
Command Mode Description
mirror add PORTS [ingress |
egress]
Bridge
Designates the mirrored ports.
ingress: ingress traffic
egress: egress traffic
To Next Page
Loading...
