Siemens S223 - Port Security Aging

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
160 A50010-Y3-C150-2-7619
To display the configuration of port security, use the following command.
Command Mode Description
show port security [PORTS] Bridge Shows port security on the port.
This is an example of configuring port security on port 7.
SWITCH(config)# bridge
SWITCH(bridge)# port security 7
SWITCH(bridge)# port security 7 maximum 10000
SWITCH(bridge)# port security 7 violation protect
SWITCH(bridge)# port security 7 mac-address 00:02:a5:74:9b:17 vlan 1
SWITCH(bridge)# show port security 7
========================================================================
port security violation aging type static maximum current
========================================================================
7 enabled protect - absolute - 10000 1
========================================================================
port vlan secure-mac-addr status in use
========================================================================
7 1 00:02:a5:74:9b:17 static -
SWITCH(bridge)# no port security 7 maximum
SWITCH(bridge)# no port security 7 violation
SWITCH(bridge)# show port security 7
========================================================================
port security violation aging type static maximum current
========================================================================
7 enabled shutdown - absolute - 1 0
========================================================================
port vlan secure-mac-addr status in use
========================================================================
SWITCH(bridge)#
7.10.2 Port Security Aging
Port security aging is to set the aging time for all secure addresses on a port. Use this
feature to remove and add PCs on a secure port without manually deleting the existing
secure MAC addresses while still limiting the number of secure addresses on a port.
Command Mode Description
port security PORTS aging
static
Enables aging for configured secure addresses.
port security PORTS aging time
<1-1440>
Configures aging time in minutes for the port. All the
secure addresses age out exactly after the time.
port security PORTS aging type
{
absolute | inactivity}
Bridge
Configures aging type.
• absolute all the secure addresses on this port age out exactly after the time (min-
utes) specified lapses and are removed from the secure address list.
• inactivity the secure addresses on this port age out only if there is no data traffic
from the secure source addresses for the specified time period.