UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
180 A50010-Y3-C150-2-7619
8.1.1.1 Creating VLAN
To configure VLAN on user’s network, use the following command.
Command Mode Description
vlan create VLANS Bridge
Creates new VLAN by assigning VLAN ID:
VLANS: enter the number of VLAN ID (from 1 to 4094).
The variable VLANS is a particular set of bridged interfaces. Frames are bridged only
among interfaces in the same VLAN.
8.1.1.2 Specifying PVID
By default, PVID 1 is specified to all ports. You can also configure PVID. To configure
PVID in a port, use the following command.
Command Mode Description
vlan pvid PORTS PVIDS Bridge
Configures VLAN PVID:
PORTS: enter the port numbers.
PVIDS: enter the PV IDs (1 to 4094 multiple entries
possible).
8.1.1.3 Assigning Port to VLAN
To assign a port to VLAN, use the following command.
Command Mode Description
vlan add VLANS PORTS {tagged
|
untagged}
Assigns a port to VLAN:
VLANS: enter the VLAN ID.
PORTS: enter the port number.
vlan del VLANS PORTS
Bridge
Deletes associated ports from specified VLAN:
VLANS: enter the VLAN ID.
PORTS: enter the port number to be deleted.
When you assign several ports to VLAN, you have to enter each port separated by a
comma without space or use dash mark “-“ to arrange port range.
8.1.1.4 Deleting VLAN
To delete VLAN, use the following command.
Command Mode Description
no vlan VLANS Bridge Deletes VLAN, enter the VLAN ID to be deleted.
When you delete VLAN, all ports must be removed from VLAN before, see the below
procedure.
i
i
i
To Next Page
Loading...
