UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
32 A50010-Y3-C150-2-7619
3.1.6 DHCP Configuration Mode
To open DHCP Configuration mode, use the command, ip dhcp pool POOL, on Global
Configuration mode as follow. Then the prompt is changed from SWITCH(config)# to
SWITCH(config-dhcp[POOL])#.
Command Mode Description
ip dhcp pool POOL Global Opens DHCP Configuration mode to configure DHCP.
DHCP Configuration mode is to configure range of IP address used in DHCP server,
group in subnet, and default gateway of subnet.
Command Description
default-router Configures a default gateway of subnet.
dns-server Configures DNS server.
range Configures a range of IP address used in DHCP server.
subnet Configures a subnet
Tab. 3.6 Main Commands of DHCP Configuration Mode
3.1.7 DHCP Option 82 Configuration Mode
To open DHCP Option 82 Configuration mode, use the command, ip dhcp option82, on
Global Configuration mode as follow. Then the prompt is changed from SWITCH(config)#
to SWITCH(config-opt82)#.
Command Mode Description
ip dhcp option82 Global
Opens DHCP Option 82 Configuration mode for DHCP
option 82 configuration.
On DHCP Option 82 Configuration mode, configure a range of IP address used in DHCP
server and designate the group in subnet and configure default gateway of the subnet.
Tab. 3.7 is the main commands of DHCP Option 82 Configuration mode of hiD 6615
S223/S323.
Command Description
policy Configures a rule for option 82 packet.
remote-id Configures a remote ID.
system-remote-id Configures the remote ID of the system.
system-circuit-id Configures the circuit ID of the system.
Tab. 3.7 Main Commands of DHCP Option 82 Configuration Mode
To Next Page
Loading...
